Default Settings For Rmon; Configuring Rmon; Configuring Rmon Alarms - Cisco Nexus 7000 Series Configuration Manual

Default Settings for RMON

• You must configure an SNMP user and a notification receiver to use the SNMP notification event type.
• You can configure an RMON alarm only on a MIB object that resolves to an integer.
• When you configure an RMON alarm, the object identifier must be complete with its index so that it
Default Settings for RMON
The following table lists the default settings for RMON parameters.
Parameters
RMON
Alarms

Configuring RMON

Note Be aware that the Cisco NX-OS commands for this feature may differ from those commands used in Cisco
IOS.

Configuring RMON Alarms

You can configure RMON alarms on any integer-based SNMP MIB object.
You can optionally specify the following parameters:
• The event number to trigger if the rising or falling threshold exceeds the specified limit.
• The owner of the alarm.
Ensure you have configured an SNMP user and enabled SNMP notifications.
Before You Begin
Make sure that you have configured an SNMP user and enabled SNMP notifications.
Procedure
Step 1
Cisco Nexus 7000 Series NX-OS System Management Configuration Guide
216
refers to only one object. For example, 1.3.6.1.2.1.2.2.1.14 corresponds to cpmCPUTotal5minRev, and
.1 corresponds to index cpmCPUTotalIndex, which creates object identifier 1.3.6.1.2.1.2.2.1.14.1.
Command or Action
configure terminal
Example:
switch# configure terminal
switch(config)#
Default
Enabled
None configured
Purpose
Enters global configuration mode.
Configuring RMON