Removing Hinge Bracket And Fitting Alcove Bracket - Fisher & Paykel ACTIVESMART Dual Installation Manual

Start with the left hinge refrigerator and repeat the process on the right hinge refrigerator.
Removing hinge bracket
Follow the steps below to remove the hinge bracket (non hinged side) and fit the alcove
bracket. This process is required for both left and right hinge refrigerators.
Top trim
Ensure the distance between the end of the top trim and the side of the cabinet is not
1
greater than 1/4" (6mm). If distance is greater than 1/4" (6mm), loosen the pan head Phillips
screws at the back of the trim and shift the trim sideways to suit.
On the right hand side (when facing the front side of the refrigerator), loosen the M5 x 10
2
pan head Phillips top trim attachment screws. Shift screws towards the centre of the trim,
(refer to A).
Remove the right hinge bracket from the left hinge refrigerator by unscrewing the
3
countersunk Phillips head screws with a Phillips head screwdriver (refer to B).
B
A
6
6

REMOVING HINGE BRACKET AND FITTING ALCOVE BRACKET

Refrigerator front side
Fitting alcove bracket
Screw the front two M5 x 8 countersunk Phillips screws (refer to C). Check that the top face
4
of the front trim is parallel to the refrigerator.
Shift M5 x 10 pan head Phillips trim attachment screws into the slots in the alcove bracket,
5
(refer to D).
– If the front trim is not parallel to the refrigerator, screw the jacking screw supplied:
M5 x 12 Socket head cap screw (refer to E) to adjust the trim position.
When the front trim is parallel to the refrigerator, secure the alcove bracket with the third
6
countersunk screw (refer to F).
C
E
Repeat process of removing hinge bracket and fitting alcove bracket on the right
hinge refrigerator.
D
F