Table of Contents
Advertisement
1
2
3
4
18
INSTALL ANTI-TIP BRACKET
Check for wall stud.
Measure the depth range of the alcove
ensuring the minimum depth range has
been met.
If required, install a spacer at the rear of
the cavity to bring depth to 24" (610mm).
Measure the height from floor to the
front overhang and mark on rear wall.
5
6
7
For solid wall installs:
Using the bracket as a guide, pre-
drill four holes into the wall or spacer.
Secure bracket using crosshead screws.
Install kit A
For masonry wall installs:
Using the bracket as a guide, pre-drill
four holes into the wall. Hammer four
masonry plugs into the wall until flush
before securing the bracket using
crosshead screws.
Install kit A
Ensure that the anti-tip bracket is
installed correctly to prevent the
possibility of the appliance tipping
forward when the door is opened.
Advertisement
Table of Contents
