Preparing For Centre Trim - Fisher & Paykel ACTIVESMART Dual Installation Manual

Remove the centre* M10 x 65 Socket head cap screws from the base of the refrigerators
1
(refer to A)
*Remove the right screw from the left hinge refrigerator.
*Remove the left screw from the right hinge refrigerator.
Attach the bottom joiner bracket using M10 x 65 Socket head cap screws (refer to B).
2
A
For 80" (2032mm) refrigerators, cut centre trim using the same method as instructed for
3
side trims (refer to separate 'Installation guide' booklet supplied with your refrigerator).
Mark out three locations for the spring clips along the centre trim to match foam pad
4
locations on cabinet.
10
!0

PREPARING FOR CENTRE TRIM

5
6
7
B
Insert right hand spring clip into the centre trim channel (refer to C).
IMPORTANT!
Ensure the bottom of the right hand spring clip is located on the right hand side of the
channel.
Insert the left hand spring clip into the centre trim channel (refer to D).
Before pushing the left hand spring clip all the way into the trim, squeeze the two spring
clips together and push home. You will hear the spring clips engage into the trim (refer to E).
Repeat for the remaining two locations on the centre trim.
C D E
CLICK!