Chevrolet Corvette Owner's Manual page 278

9. Press the on/off button (2) to
turn the compressor on.
The compressor will inflate the
tyre with air only.
10. Inflate the tyre to the
recommended inflation
pressure using the pressure
gauge (3). The recommended
inflation pressure can be found
on the Tyre and Loading
Information label. See Tyre
Pressure 0 258.
The pressure gauge (3) may
read higher than the actual tyre
pressure while the compressor
is on. Turn the compressor off
to get an accurate reading. The
compressor may be turned on/
off until the correct pressure is
reached.
If you inflate the tyre higher
than the recommended
pressure you can adjust the
excess pressure by pressing
the pressure deflation
button (4) until the proper
pressure reading is reached.
This option is only functional
when using the air only
hose (7).
11. Press the on/off button (2) to
turn the tyre sealant and
compressor kit off.
Be careful while handling the
tyre sealant and compressor kit
as it could be warm after
usage.
12. Unplug the power plug (8) from
the accessory power outlet in
the vehicle.
13. Disconnect the air only hose
(7) from the tyre valve stem, by
turning it anticlockwise, and
replace the tyre valve
stem cap.
14. Replace the air only hose (7)
and the power plug (8) and
cord back in its original
location.
15. Place the equipment in the
original storage location in the
vehicle.
Vehicle Care
The tyre sealant and compressor kit
has an accessory adapter located in
a compartment on the bottom of its
housing that may be used to inflate
air mattresses, balls, etc.
Removal and Installation of the
Sealant Canister
To remove the sealant canister:
1. Unwrap the sealant hose.
2. Press the canister release
button (9).
3. Pull up and remove the
canister.
277