Chevrolet Corvette Owner's Manual page 161

160 Driving and Operating
To remove the air deflector:
1. Remove the four front (2) and
three rear (4) front
compartment air deflector
screws.
2. Remove the forward
push pin (1).
3. Remove the front compartment
air deflector (3) by tipping the
rear down and sliding it out
from under the lower deflector
panel.
When the track events are
complete, re-install this panel.
Z07 Performance Package
Z06 with the Z07 Performance
Package has installed Stage 2 and
Stage 3 Aero Packages, which
consist of a front spoiler with short
end caps, sill extensions, and a rear
spoiler.
Stage 3 Aero components are
delivered but not installed on the
vehicle. These are intended to be
installed for track use only. The
components include:
Front splitter tall end caps that
replace the front splitter short
end caps
A center transparent wicker bill
for the rear spoiler
Warning
Changing the following track
settings could reduce tire traction
and could cause a crash. Do not
change the track settings.
The track settings for the Z07
Performance Package with the
Stage 3 Aero Package are:
The front splitter tall end caps
installed
The center transparent wicker
bill installed all the way up on
the rear spoiler
The Driver Mode Selector in
Track Mode
Vehicles with Performance
Package-Carbon Fibre (CFZ)
Vehicles with the Performance
Package-Carbon Fibre (CFZ) have
an installed aero package which
consists of a front spoiler with short
end caps, sill extensions, and a rear
spoiler. A center transparent wicker
bill for the rear spoiler is delivered
but not installed. This is intended to
be installed for track use only.
Front Brake Cooling Duct Kit
The following installation procedure
is for Z06 vehicles and should be
installed prior to any track events.
The cooling ducts should be