installed prior to any track events.
The cooling ducts improve brake
cooling during track events.
To install the cooling ducts and
deflector:
1. Remove the front wheels.
Refer to the procedure in the
vehicle service manual.
Steps 2, 3, and 4 are optional
on certain vehicles.
2. Remove the fastener (1) from
the rear of the control arm
deflector (2).
3. Remove the remaining three
fasteners (1) from the
deflector (2).
4. Remove the deflector (2).
Driving and Operating
5. Remove the adhesive tape
from the rubber pads and
install them on the front airbox
as shown. Allow it to dry for
five minutes.
6. Remove the adhesive tape
from the rubber pads and
install them on the rear airbox
as shown. Allow it to dry for
five minutes.
161