Rear Axle - Chevrolet Corvette Owner's Manual

Hide thumbs Also See for Corvette:
Table of Contents

Advertisement

238
Vehicle Care
****) If connection to the mains is by
the flat Euro connector, the battery
charger has the IP63 insulation
class except for in Switzerland
where IP65 applies.
*****) For Switzerland and United
Kingdom an adapter is required.
TEMPERATURE PROTECTION
The charger is protected against
overheating. The power is reduced
when the ambient temperature
increases.
The charger may be perceived as
being hot during charging. This is
completely normal, although you
should avoid placing it on a
sensitive surface.
MAINTENANCE
The charger is maintenance free.
Please note that dismantling the
charger is not permitted and will
void the warranty. A defective mains
cable must be replaced. Keep your
charger clean.
Wipe it with a soft tissue and mild
cleaning liquid. The charger must be
disconnected before cleaning.
BATTERY CABLES
The model 1052 charger is
equipped with an accessory power
outlet for connecting to the vehicle.
BULK CHARGING TIME
The table shows the duration of the
Bulk step-up to about 80% state of
charge.
Battery
size (Ah)
Time (h)
70

Rear Axle

When to Check Lubricant
It is not necessary to regularly
check rear axle fluid unless a leak is
suspected or an unusual noise is
heard. A fluid loss could indicate a
problem. Have it inspected and
repaired.
How to Check Lubricant
17
To get an accurate reading, the
vehicle should be on a level
surface.
The fluid level should be at or within
13 mm (0.5 in) of the bottom of the
fill plug hole threads. If it is at this
level, no additional fluid is needed.
If the fluid level is below 13 mm
(0.5 in), add fluid until it is above
this level.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents