Recording Overdubs - DigiTech TRIO+ Band Creator+ Looper Owner's Manual

Recording Overdubs

Overdub recording can be initiated while a loop is playing or from a stopped state.
To record an overdub while a loop is playing:
1. Press the LOOPER footswitch once to enable overdub recording (the LOOPER LED will turn solid amber).
You can begin playing your overdubbed parts over the loop.
2. When you are done overdubbing, press the LOOPER footswitch to stop overdub recording (the LOOPER
LED will turn green and the looper will stop recording the overdub and resume playback).
TIP: To undo the overdub so you can re-record it, follow the instructions described in 'Undoing/
Redoing The Last Recorded Loop/Overdub' on page 25.
To record overdubs from a stopped state:
1. Press the LOOPER footswitch once to arm overdub recording (the LOOPER LED will flash amber).
2. Start playing or press the BAND footswitch to begin overdub recording.
3. When you are done overdubbing, press the LOOPER footswitch to stop overdub recording (the LOOPER
LED will turn green and the looper will stop recording the overdub and resume playback).
TIP: To undo the overdub so you can re-record it, follow the instructions described in 'Undoing/
Redoing The Last Recorded Loop/Overdub' on page 25.
NOTE: Each time a new overdub is recorded, the previously recorded overdub is mixed with the original
loop.
24