DigiTech TRIO+ Band Creator+ Looper Owner's Manual page 13

14. LOOPER Footswitch & LED
Press this footswitch to record loops and overdubs. For more information on using the looper, see
'Recording Loops & Overdubs' on page 22.
The LOOPER LED indicates the status of the looper for the selected song part. The following table describes
the available states of the LOOPER LED.
LOOPER LED
Off
Rapidly
Flashing Red
Solid Bright
Red
Solid Bright
Green
Rapidly
Flashing
Amber
Solid Amber
Solid Dim
Green
State
No loop has been recorded for the selected part and the looper is
Loop
not armed for recording. Press the LOOPER footswitch to arm the
Hasn't Been
looper for recording — note that the AUDIOLASTIC™ LED must be
Recorded
off to record loops.
Looper The looper is armed for recording and recording will begin when
Armed & you start playing (when the looper is armed from a stopped state)
Ready To or when the song part returns to the start (when the looper is
Record armed during band playback).
Recording
The looper is recording what you are playing.
Loop
A loop has been recorded for the selected part and is playing back.
Playing Loop
Press the LOOPER footswitch to record overdubs.
Looper
Armed For Playback is stopped, the looper is armed for overdub recording, and
Overdub recording will begin when you start playing.
Recording
Recording The looper is recording an overdub. Press the LOOPER footswitch to
Overdub stop overdub recording.
A loop has been recorded, but looper and band playback is
Loop stopped. Press the BAND footswitch to start band and loop
playback. Press the LOOPER footswitch to arm overdub recording.
Recorded
Hold the LOOPER footswitch for 2 seconds to clear the loop.
& Playback
Immediately hold the LOOPER footswitch again for 2 seconds to
Stopped
restore the cleared loop.
Description
10