Pan Motor Assembly Replacement - Philips VL1000 TS Service Manual

Pan Motor Assembly Replacement

Parts:
ASSEMBLY, PAN MOTOR (21.9663.1815)
Tools:
#2 Phillips screwdriver
To remove and replace pan motor assembly:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove yoke leg covers by removing four 6-32x3/8" PTB screws on each
Step 3. Remove crossmember assembly from yoke by removing sixteen 10-32x1/2"
Step 4. At crossmember assembly, remove pan wire shield by removing four
Step 5. At pan motor assembly, loosen four 6-32x1" PPB screws. Slide assembly
Step 6. Remove four 6-32x1" PPB screws and #6 flat washers and remove pan motor
Step 7. Replace pan motor assembly by doing steps 2 through 6 in reverse. (Belt
02. 96 63. 001 0 F
side (Figure 2-27).
PPB screws.
4-40x3/8" PPZ screws.
forward and remove belt from pulley.
assembly (nut plate will come loose also).
tension is automatically set by spring.)
14-May-2009
2
M :
AINTENANCE
51