Fan/Temp Switch Assembly Replacement - Philips VL1000 TS Service Manual

Fan/Temp Switch Assembly Replacement

Note: Fan does not operate under normal luminaire operating conditions.
Parts:
CABLE ASSEMBLY, FAN/TEMP SWITCH (23.9663.2009)
Tools:
#2 Phillips screwdriver
To remove and replace fan/temp switch assembly:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove edge/dimmer/color bulkhead. Refer to
Step 3. At fan, remove four 6-32 x 3/8 " PPSS black screws and 6-32 nylon insert
Step 4. Replace assembly by doing steps 2 and 3 in reverse.
02. 96 63. 001 0 F
Replacement" on page
hex nuts and remove fan/temp switch assembly
Figure 2-19: Fan/Temp Switch Assembly Replacement
14-May-2009
40.
6-32 Nylon Insert Hex Nut
M
AINTENANCE
"Edge/Zoom/Color Bulkhead
(Figure 2-19).
6-32x3/8" PPSS Screw
2
:
41