Shutter Assembly Replacement - Philips VL1000 TS Service Manual

VARI❋LITE® - VL1000™ ERS L

Shutter Assembly Replacement

Parts:
ASSEMBLY, SHUTTER (21.9663.1300) (Old Version) or
ASSEMBLY, SHUTTER 6 ROLLERS (21.9663.1350) (New Version)
Tools:
#2 Phillips long handle screwdriver+
To remove and replace shutter assembly:
Step 1. Disconnect luminaire AC input cable from power source.
CAUTION: The rear assembly is heavy and will remain attached by lamp wires.
Place luminaire on tech bench before removing rear assembly.
Step 2. Remove front cover, rear head assembly and gobo wheel bulkhead. Refer to
Step 3. Remove yoke leg cover (side with menu display) by removing two 6-32x1/2"
36
S
UMINAIRE ERVICE
"Gobo Wheel Bulkhead Replacement" on page
PPB screws and two 6-32x3/8" PPB screws
6-32x1/2" PPB Screw
Yoke Leg Cover
6-32x3/8" PPB Screw
Figure 2-14: Removing Yoke Leg Cover to Access Controller PCB
14-May-2009
M
ANUAL
Controller PCB
32.
(Figure 2-14).
NOTE:
Head not shown for clarity.
02. 96 63. 001 0 F