Beam-Size Iris Assembly Replacement - Philips VL1000 TS Service Manual

VARI❋LITE® - VL1000™ ERS L

Beam-Size Iris Assembly Replacement

Note: This procedure not applicable to all units.
Parts:
ASSEMBLY, IRIS (21.9663.1400)
Tools:
#2 Phillips screwdriver
To remove and replace beam-size iris assembly:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove front cover. Refer to
Step 3. At beam-size iris assembly, disconnect motor connectors
Step 4. At side rails, remove four 10-32x3/8" PPB screws and #10 split-lock washers
Step 5. Replace iris assembly by doing steps 2 through 4 in reverse.
42
S
UMINAIRE ERVICE
and remove iris assembly.
10-32x3/8" PPB Screw
#10 Split-Lock Washers
Beam-Size Iris Assembly
Head Assembly
Figure 2-20: Beam-Size Iris Assembly Replacement
14-May-2009
M
ANUAL
"Front Cover Removal" on page
NOTE:
Yoke not shown for clarity.
26.
(Figure 2-20).
02. 96 63. 001 0 F