Gobo Wheel Bulkhead Replacement - Philips VL1000 TS Service Manual

VARI❋LITE® - VL1000™ ERS L

Gobo Wheel Bulkhead Replacement

Parts:
ASSEMBLY, GOBO BULKHEAD INCANDESCENT (21.9663.1200) - TS/TI
ASSEMBLY, GOBO BULKHEAD ARC (21.9663.1600) - AS/AI
Tools:
#2 Phillips long handle screwdriver
To remove and replace gobo wheel bulkhead:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove front cover. Refer to
CAUTION: The rear assembly is heavy and will remain attached by lamp wires.
Place luminaire on tech bench before removing rear assembly.
Step 3. At side rails, remove four 10-32x5/8" PPB screws and #10 split lock washers
Step 4. At gobo bulkhead, disconnect all motor and sensor wiring.
Step 5. At side rails, remove four 10-32x3/8" PPB screws and #10 split-lock
Step 6. Remove gobo bulkhead.
Step 7. Replace by doing steps 2 through 6 in reverse.
32
S
UMINAIRE ERVICE
(Figure 2-12). (Side rail spacers will come loose also.) Pull rear head
assembly away from front head assembly.
washers.
14-May-2009
M
ANUAL
"Front Cover Removal" on page 26.
02. 96 63. 001 0 F