Rear Head Assembly Removal
This procedure is necessary in order to access some components such as the gobo
wheel bulkhead and shutter assembly. Refer to as needed.
Tools:
#2 Phillips long handle screwdriver
To remove rear head assembly:
Step 1. Disconnect luminaire AC input cable from power source.
CAUTION: The rear head assembly is heavy and will remain attached by lamp wires.
Place luminaire on tech bench before removing rear assembly.
Step 2. At side rails, remove four 10-32x5/8" PPB screws and #10 split lock washers
Step 3. Pull rear head assembly away from front head assembly.
Step 4. Re-install by doing steps 2 and 3 in reverse.
Front Head Assembly
NOTE:
Yoke not shown for clarity.
02. 96 63. 001 0 F
(Figure
2-8). (Side rail spacers will come loose also.)
Figure 2-8: Rear Head Assembly Removal and Replacement
14-May-2009
M
Rear Head Assembly
Lamp Wires
#10 Split
Side Rail Spacer
Lock Washer
2
:
AINTENANCE
10-32x5/8"
PPB Screw
27