Tilt Encoder Pcb Replacement - Philips VL1000 TS Service Manual

VARI❋LITE® - VL1000™ ERS L

Tilt Encoder PCB Replacement

Parts:
PCB ASSY, PAN/TILT ENCODER (24.9661.9629)
Tools:
#2 Phillips screwdriver
To remove and replace tilt encoder PCB:
Step 1. Disconnect luminaire AC input cable from power source.
Step 2. Remove yoke leg cover (side with menu display) by removing four 6-32x3/
Step 3. As shown in
Step 4. Disconnect connectors at J1 and J2.
Step 5. Remove encoder PCB.
Step 6. Replace encoder PCB by doing steps 2 through 5 in reverse.
Tilt Encoder PCB
4-32 Screw
48
S
UMINAIRE ERVICE
8" PTB screws.
Figure 2-25, at tilt encoder PCB, remove two 4-32 screws.
Figure 2-25: Tilt Encoder PCB Replacement
14-May-2009
M
ANUAL
02. 96 63. 001 0 F