Assigning A Hybrid Port To A Vlan - HP 6600 Configuration Manual

Step
3. Configure the link type of
the ports as trunk.
4. Assign the trunk ports to
the specified VLANs.
5. Configure the PVID of the
trunk ports.
To change the link type of a port from trunk to hybrid or from hybrid to trunk, you must set the link type
to access first.
After configuring the PVID for a trunk port, you must use the port trunk permit vlan command to configure
the trunk port to allow packets from the PVID to pass through.

Assigning a hybrid port to a VLAN

A hybrid port can carry multiple VLANs. You can assign it to a VLAN in interface view. Before assigning
a hybrid port to a VLAN, create the VLAN first.
To assign a hybrid port to one or multiple VLANs:
Step
1. Enter system view.
2. Enter interface view or port
group view.
3. Configure the link type of
the ports as hybrid.
4. Assign the hybrid ports to
the specified VLANs.
5. Configure the PVID of the
hybrid ports.
To change the link type of a port from trunk to hybrid or from hybrid to trunk, you must set the link type
to access first.
Command
port link-type trunk
port trunk permit vlan
{ vlan-list | all }
port trunk pvid vlan vlan-id
Command
system-view
•
Enter Layer 2 Ethernet
interface view:
interface interface-type
interface-number
•
Enter Layer 2
aggregation interface
view:
interface
bridge-aggregation
interface-number
•
Enter port group view:
port-group manual
port-group-name
port link-type hybrid
port hybrid vlan vlan-list
{ tagged | untagged }
port hybrid pvid vlan
vlan-id
97
Remarks
By default, all ports are access ports.
By default, a trunk port carries only VLAN 1.
Optional.
By default, the PVID is VLAN 1.
Remarks
N/A
Use one of the commands.
•
The configuration made in Ethernet
interface view applies only to the port.
•
The configuration made in port group
view applies to all ports in the port group.
•
The configuration made in Layer 2
aggregate interface view applies to the
aggregate interface and its aggregation
member ports. If the system fails to apply
the configuration to the aggregate
interface, it stops applying the
configuration to aggregation member
ports. If the system fails to apply the
configuration to an aggregation member
port, it skips the port and moves to the
next member port.
By default, all ports are access ports.
By default, a hybrid port allows only packets
of VLAN 1 to pass through untagged.
Optional.
By default, the PVID is VLAN 1.