HP 6600 Configuration Manual page 213

[PE3-classifier-up_uplink] if-match customer-vlan-id 10
[PE3-classifier-up_uplink] if-match service-vlan-id 200
[PE3-classifier-up_uplink] quit
[PE3] traffic behavior up_uplink
[PE3-behavior-up_uplink] remark customer-vlan-id 30
[PE3-behavior-up_uplink] quit
[PE3] qos policy up_uplink
[PE3-qospolicy-up_uplink] classifier up_uplink behavior up_uplink
[PE3-qospolicy-up_uplink] quit
# Configure customer-side port GigabitEthernet 4/0/1 as a trunk port, assign it to VLAN 200, and
apply uplink policy down_uplink to incoming traffic and downlink policy down_downlink to
outgoing traffic on the port.
[PE3] interface GigabitEthernet 4/0/1
[PE3-GigabitEthernet4/0/1] port link-type trunk
[PE3-GigabitEthernet4/0/1] port trunk permit vlan 200
[PE3-GigabitEthernet4/0/1] qos apply policy down_uplink inbound
[PE3-GigabitEthernet4/0/1] qos apply policy down_downlink outbound
[PE3-GigabitEthernet4/0/1] quit
# Set network-side port GigabitEthernet 4/0/2 as a trunk port, assign it to VLAN 200, and apply
uplink policy up_uplink to outgoing traffic on the port.
[PE3] interface GigabitEthernet 4/0/2
[PE3-GigabitEthernet4/0/2] port link-type trunk
[PE3-GigabitEthernet4/0/2] port trunk permit vlan 200
[PE3-GigabitEthernet4/0/2] qos apply policy up_uplink outbound
[PE3-GigabitEthernet4/0/2] quit
4. Configure PE 4:
# Configure an uplink policy test to add outer VLAN tag 200 to VLAN 30 tagged traffic.
<PE4> system-view
[PE4] traffic classifier test
[PE4-classifier-test] if-match customer-vlan-id 30
[PE4-classifier-test] quit
[PE4] traffic behavior test
[PE4-behavior-test] nest top-most vlan-id 200
[PE4-behavior-test] quit
[PE4] qos policy test
[PE4-qospolicy-test] classifier test behavior test
[PE4-qospolicy-test] quit
# Assign port GigabitEthernet 4/0/1 to VLAN 200.
[PE4] interface GigabitEthernet 4/0/1
[PE4-GigabitEthernet4/0/1] port link-type trunk
[PE4-GigabitEthernet4/0/1] port trunk permit vlan 200
# Configure port GigabitEthernet 4/0/2 as a hybrid port, and assign it to VLAN 200 as un
untagged member, so the port forwards VLAN 200 traffic with the VLAN tag removed. Enable
basic QinQ, and apply uplink policy test to incoming traffic on the port.
[PE4] interface GigabitEthernet 4/0/2
[PE4-GigabitEthernet4/0/2] port link-type hybrid
[PE4-GigabitEthernet4/0/2] port hybrid vlan 200 untagged
204