One-To-Two And Two-To-Two Vlan Mapping Configuration Example - HP 6600 Configuration Manual

One-to-two and two-to-two VLAN mapping configuration
example
Network requirements
As shown in
respectively. The two sites use different VPN access services from different service providers, SP 1 and SP
2. SP 1 assigns VLAN 100 for Site 1, and SP 2 assigns VLAN 200 for Site 2.
Configure one-to-two and two-to-two VLAN mappings to enable the two branches to communicate
across networks SP 1 and SP 2.
Each router is installed with SAP modules (for example, 48-GBE SAP modules) operating in bridge mode.
Figure 72 Network diagram
Configuration procedure
1. Configure PE 1:
# Configure an uplink policy test to add outer VLAN tag 100 to VLAN 10 tagged traffic.
<PE1> system-view
[PE1] traffic classifier test
[PE1-classifier-test] if-match customer-vlan-id 10
[PE1-classifier-test] quit
[PE1] traffic behavior test
[PE1-behavior-test] nest top-most vlan-id 100
[PE1-behavior-test] quit
[PE1] qos policy test
[PE1-qospolicy-test] classifier test behavior test
[PE1-qospolicy-test] quit
# Configure customer-side port GigabitEthernet 4/0/1 as a hybrid port, and assign it to VLAN
100 as an untagged member, so the port forwards VLAN 100 traffic with the VLAN tag removed.
On the port, enable basic QinQ, and apply uplink policy test to incoming traffic.
[PE1] interface GigabitEthernet 4/0/1
[PE1-GigabitEthernet4/0/1] port link-type hybrid
[PE1-GigabitEthernet4/0/1] port hybrid vlan 100 untagged
[PE1-GigabitEthernet4/0/1] qinq enable
[PE1-GigabitEthernet4/0/1] qos apply policy test inbound
Figure 72, two VPN A branches, Site 1 and Site 2, are in VLAN 10 and VLAN 30,
202