Configuration Examples; Example For Configuring Link Aggregation In Manual Load Balancing Mode; Figure 2-5 Networking Diagram For Configuring Link Aggregation In Manual Load Balancing Mode - Huawei Quidway S9300 Configuration Manual

2 Link Aggregation Configuration
Procedure
l
l
l
----End

2.7 Configuration Examples

This section provides several configuration examples of link aggregation in manual load
balancing mode and in static LACP mode.

2.7.1 Example for Configuring Link Aggregation in Manual Load Balancing Mode

2.7.2 Example for Configuring Link Aggregation in Static LACP Mode
2.7.1 Example for Configuring Link Aggregation in Manual Load
Balancing Mode
Networking Requirements
As shown in
between the S9300 and BRAS must ensure high reliability, and data traffic needs to be load
balanced among the LPUs of the S9300. To meet this requirement, you need to configure an
inter-board Eth-Trunk on the S9300.

Figure 2-5 Networking diagram for configuring link aggregation in manual load balancing mode

DSLAM
2-20
Run the display eth-trunk [ trunk-id [ interface interface-type interface-number ] ]
command to display the status of the link aggregation group.
Run the display lacp statistics eth-trunk [ trunk-id [ interface interface-type interface-
number ] ] command to display the statistics of sent and received LACP packets.
Run the display trunkmembership eth-trunk trunk-id command to display the member
interfaces of the Eth-Trunk.
Figure 2-5, the S9300 is connected to the BRAS through an Eth-Trunk. The link
BRAS
GE3/0/0
S9300
GE1/0/0
VLAN 100-150
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Eth-Trunk 60
Eth-Trunk 120
GE2/0/0
GE1/0/5
VLAN 151-200
DSLAM
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)