Checking The Configuration; Snmp Configuration Examples; Example For Configuring A Device To Communicate With An Nm Station By Using Snmpv1 - Huawei S9300 Configuration Manual

S9300&S9300E Terabit Routing Switch
Configuration Guide - Network Management
The lifetime of every trap message depends on the number of generated trap messages. If the
switch frequently generates trap messages, a longer lifetime can be set for every trap message
to prevent trap messages from being lost.
----End

1.4.6 Checking the Configuration

After SNMPv3 functions are configured, you can view the SNMPv3 configurations.
Prerequisites
The configurations of basic SNMPv3 functions are complete.
Procedure
l
l
l
l
l
l
l
l
l
l
----End

1.5 SNMP Configuration Examples

This section provides several configuration examples of SNMP. The configuration roadmap in
the examples will help you understand the configuration procedures. Each configuration
example provides information about the networking requirements, configuration notes, and
configuration roadmap.
1.5.1 Example for Configuring a Device to Communicate with an
NM Station by Using SNMPv1
This section provides an example to describe how to configure a device to communicate with
an NM station by using SNMPv1 and how to specify the MIB objects that can be managed by
the NM station.
Issue 01 (2012-03-15)
Run the display snmp-agent usm-user [ engineid engineid | group group-name |
username user-name ]
Run the display snmp-agent sys-info version command to check the enabled SNMP
version.
Run the display acl acl-number command to check the rules in the specified ACL.
Run the display snmp-agent mib-view command to check the MIB view.
Run the display snmp-agent sys-info contact command to check the equipment
administrator's contact information.
Run the display snmp-agent sys-info location command to check the location of the
device.
Run the display snmp-agent target-host command to view information about all
destination hosts, such as the IP addresses.
Run the display snmp-agent trap command to view whether the router is enabled to send
alarms to the NM station.
Run the display snmp-agent statistics command to view the statistics of SNMP packets.
Run the display snmp-agent extend error-code status command to check whether the
SNMP extended error code feature is enabled.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
*
command to check user information.
1 SNMP Configuration
31