Creating An Eth-Trunk; Figure 2-2 Networking Diagram For Configuring Link Aggregation In Load Balancing Mode - Huawei Quidway S9300 Configuration Manual

2 Link Aggregation Configuration
2.3.5 (Optional) Configuring the Load Balancing Mode
2.3.6 Checking the Configuration
2.3.1 Establishing the Configuration Task
Applicable Environment
When the bandwidth or the reliability of two devices should be increased and either of the two
devices does not support LACP, you should create an Eth-Trunk in manual load balancing mode
on the S9300 and add member interfaces to the Eth-Trunk to increase the bandwidth and improve
reliability of devices.
As shown in

Figure 2-2 Networking diagram for configuring link aggregation in load balancing mode

S9300-A Eth-Trunk 1
Pre-configuration Tasks
Before configuring an Eth-Trunk in manual load balancing mode, complete the following tasks:
l
l
Data Preparation
To configure an Eth-Trunk in manual load balancing mode, you need the following data.
No.
1
2

2.3.2 Creating an Eth-Trunk

Procedure
Step 1 Run:
system-view
The system view is displayed.
2-4
Figure 2-2, Eth-Trunks are created between S9300-A and S9300-B.
Eth-Trunk
Powering on the S9300
Creating the Eth-Trunks
Data
Number of the Eth-Trunk in manual load balancing mode
Type and number of the member interface
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
S9300-B
Eth-Trunk 1
Issue 03 (2009-08-20)