Configuring The Eth-Trunk To Work In Static Lacp Mode - Huawei Quidway S9300 Configuration Manual

2 Link Aggregation Configuration
Pre-configuration Tasks
Before configuring an Eth-Trunk in static LACP mode, complete the following tasks:
l
l
Data Preparation
To configure basic functions of link aggregation in static LACP mode, you need the following
data.
No.
1
2
3

2.5.2 Configuring the Eth-Trunk to Work in Static LACP Mode

Context
Do as follows on the S9300 where you need to configure an Eth-Trunk of static LACP mode.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk view is displayed.
Step 3 Run:
mode lacp-static
The Eth-Trunk is configured to work in static LACP mode.
By default, an Eth-Trunk works in manual load balancing mode.
2-12
Powering on the S9300
Creating the Eth-Trunks
Data
Number of the Eth-Trunk
Type and number of the member interface
Upper threshold of the number of active interfaces
NOTE
Check whether the Eth-Trunk contains member interfaces before you configure the operation mode of the
Eth-Trunk. If the Eth-Trunk contains member interfaces, the operation mode of the Eth-Trunk cannot be
changed. To delete member interfaces from the Eth-Trunk, run the undo eth-trunk trunk-id command in
the interface view or run the undo trunkport interface-type interface-number command in the Eth-Trunk
view.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Issue 03 (2009-08-20)