Maintaining The Information Center; Configuration Examples; Example For Outputting Information To The Console Interface - Huawei S9300 Configuration Manual

2 Information Center Configuration
ff0c0000
416c0000
70180000
¡¡
For details about the display, refer to the Quidway S9300 Terabit Routing Switch Command
Reference.

2.5 Maintaining the Information Center

This section describes how to maintain the information center.
Context
Statistics of the information center cannot be restored after you clear it. So, confirm the action
before you use the command.
Procedure
l
----End

2.6 Configuration Examples

This section provides several configuration examples of the information center.

2.6.1 Example for Outputting Information to the Console Interface

2.6.2 Example for Outputting Log Information to the Log Host
2.6.1 Example for Outputting Information to the Console Interface
Networking Requirements
As shown in
host.
The S9300, as shown in
administrator should monitor and debug the QoS module for a long time. At that time, you can
output debugging information, log information, and trap information about the QoS module to
the log host. Thus, the administrator can analyze the running status of the QoS module.
2-16
BASETRAP
BFD
BGP
CAUTION
In user view, run:
reset info-center statistics
Statistics of the information center are cleared.
NOTE
Debugging affects the performance of the S9300. Therefore, after debugging, if no special requirements
are specified, disable it immediately, when the S9300 is running.
Figure 2-3, there is a reachable route between Eth 0/0/0 on the S9300 and the log
Figure
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
0 0
0 0
0 0
2-3, is at the debugging stage. It is required that the network
Quidway S9300 Terabit Routing Switch
Configuration Guide - Device Management
0
0
0
Issue 02 (2009-08-06)