Optional) Setting The Duplex Mode; Optional) Setting The Rate Of An Interface - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
Step 2 Run:
interface interface-type interface-number
The Ethernet electrical interface view is displayed.
Step 3 Run:
mdi { across | auto | normal }
The cable type is set for the Ethernet electrical interface.
By default, an Ethernet electrical interface automatically identifies the cable type.
----End

1.3.4 (Optional) Setting the Duplex Mode

Context
Do as follows on the S9300 where you need to set the duplex mode of interfaces.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The Ethernet electrical interface view is displayed.
Step 3 Run:
undo negotiation auto
The auto-negotiation mode is disabled on the Ethernet electrical interface.
Step 4 Run:
duplex { full | half }
The duplex mode is set for the Ethernet electrical interface.
By default, the duplex mode of an Ethernet electrical interface is full-duplex when auto-
negotiation is disabled on the interface.
----End

1.3.5 (Optional) Setting the Rate of an Interface

Context
Do as follows on the S9300 where you need to set the rate of interfaces.
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1 Ethernet Interface Configuration
1-5