Optional) Setting The Timeout Interval For Receiving Lacp Packets; Checking The Configuration - Huawei Quidway S9300 Configuration Manual

Quidway S9300 Terabit Routing Switch
Configuration Guide - Ethernet
2.5.8 (Optional) Setting the Timeout Interval for Receiving LACP
Packets
Context
Do as follows on the S9300 where you need to set the timeout interval for receiving LACP
packets.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface eth-trunk trunk-id
The Eth-Trunk view is displayed.
Step 3 Run:
lacp timeout { fast | slow }
The timeout for receiving LACP protocol packets the Eth-Trunk is set.
----End

2.5.9 Checking the Configuration

Procedure
l
l
----End
Example
By running the display trunkmembership eth-trunk command, you can find that the operation
mode of the Eth-Trunk is Static and you can see the number of member interfaces, number of
member interfaces in Up state, and information about member interfaces.
<Quidway> display trunkmembership eth-trunk 1
Trunk ID: 1
used status: VALID
TYPE: ethernet
Issue 03 (2009-08-20)
NOTE
After the lacp timeout command is used, the local end informs the peer end of the timeout interval
l
through LACP packets. If the fast is selected, the interval for sending LACP packets is 1 second. If
the slow keyword is selected, the interval for sending LACP packets is 30 seconds.
You can select different keywords on the two ends. To facilitate the maintenance, however, it is
l
recommended that you select the same keyword on both ends.
Run the display trunkmembership eth-trunk trunk-id command to display the member
interfaces of the Eth-Trunk.
Run the display eth-trunk [ trunk-id [interface interface-type interface-number ] ]
command to display information about the Eth-Trunk and member interfaces.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Link Aggregation Configuration
2-17