Care And Maintenance - Roland Color CAMM PC-50 User Manual

10 Care and Maintenance

Cleaning with cleaning sheet
Soiling which cannot be removed by ordinary cleaning is removed using a cleaning sheet.
NOTICE
• Do not use any cleaning sheet that has a damaged surface such as cuts, tears or creases.
• The printing head can be damaged by dust.
• The Pinch rollers should be set over the black bands at either end of the sheet, to ensure that the head is
restricted to the center cleaning area of the sheet and cannot pass over marks left by the pinch rollers.
• Store the cleaning sheet in a clean place and wipe the cleaning surface with a "lint free" cloth before use.
1
5
Keep pushing
the CLEANINIG key,
and switch on
the power
4
LOAD
the cleaning sheet
Matt face is up side
Position of the sheet and pinch rollers (levers)
shown from the top
Grit roller
This is the side of the cleaning surface (non glossy surface)!
7
After cleaning has finished, switch off the power and remove the sheet.
18
TAKE OUT
the ink-ribbon
cartridge
Lower the sheet loading levers to secure
the material in place.
Pinch rollers (levers)
光沢の無い面がクリーニング面です。
Cleaning sheet
2
REMOVE
the blade holder
Head cleaning is finished when the
carriage stops moving.
Right side of
the sheet to be
placed at front
and rear guide
lines
3
Set the Right Hand
pinch roller to the right
hand limit of its travel
Press the SETUP key
6