Safety Instructions And Warnings - NETGEAR GC510P Hardware Installation Manual

Insight Managed 8-Port Gigabit Ethernet PoE+ Smart Cloud Switch with 2 SFP Fiber Ports
• AutoSensing and autonegotiating capabilities for all ports.
• Auto Uplink™ technology is supported on all ports.
• Automatic address learning function to build the packet-forwarding information table. The table contains
up to 16K Media Access Control (MAC) addresses.
• Store-and-forward transmission to remove bad packets from the network.
• Active flow control to minimize packet loss and frame drops.
• Half-duplex backpressure control.
• Per-port status LEDs and system status LEDs:
- System Power LED (front and back panels)
- Cloud Connection LED (front and back panels)
- Fan LED (model GC510PP only)
- PoE Max or Fault LED
- Per-port link, speed, and activity LED for copper ports
- Per-port PoE status LED for copper ports
- Per-port link and activity LED for SFP fiber ports
• NETGEAR green power-saving features:
- Energy efficiency mode that fully conforms to the IEEE 802.3az standard
- Per-port automatic change to a lower power mode when the port link is down

Safety Instructions and Warnings

Use the following safety guidelines to ensure your own personal safety and to help protect your system from
potential damage.
To reduce the risk of bodily injury, electrical shock, fire, and damage to the equipment, observe the following
precautions:
• This product is designed for indoor use only in a temperature-controlled (0–50°C) and humidity-controlled
(90 percent maximum relative humidity, noncondensing) environment.
Any device that is located outdoors and connected to this product must be properly grounded and surge
protected.
To the extent permissible by applicable law, failure to follow these guidelines can result in damage to
your NETGEAR product, which might not be covered by NETGEAR's warranty.
• Observe and follow service markings:
- Do not service any product except as explained in your system documentation.
- Opening or removing covers that are marked with the triangular symbol with a lightning bolt can
expose you to electrical shock. We recommend that only a trained technician services components
inside these compartments.
Introduction
8