Poor Wall-Mounting Position - NETGEAR GC510P Hardware Installation Manual

Insight Managed 8-Port Gigabit Ethernet PoE+ Smart Cloud Switch with 2 SFP Fiber Ports
Leave about 6 mm (¼ inch) of each screw protruded from the wall so that you can insert the screws
into the holes on the bottom of the switch.
5. Line up the holes on the bottom panel of the switch with the screws in the wall and mount the switch to
the wall.

Poor Wall-Mounting Position

To prevent the switch from tilting, do not wall-mount the switch vertically with the back panel facing right
(that is, with the cables on the right). Whether you use two or four screws, the switch will tilt in this position.
Figure 8. Poor wall-mounting position
Installation
30