Step 4: Install The Switch; Install The Switch On A Flat Surface; Wall-Mount The Switch - NETGEAR GC510P Hardware Installation Manual

Insight Managed 8-Port Gigabit Ethernet PoE+ Smart Cloud Switch with 2 SFP Fiber Ports
• Rack-mounting screws
• Installation guide
• Rubber footpads for tabletop installation
5. If any item is missing or damaged, contact your local NETGEAR reseller for replacement.

Step 4: Install the Switch

You can also use any off-the-shelf 75 mm VESA standard mount to secure the switch to a wall, a pole, or
another surface.
You can place the switch on a flat surface, attach it to a wall, or install it in a standard 19-inch
(48.26-centimeter) network equipment rack.

Install the Switch on a Flat Surface

The switch ships with four self-adhesive rubber footpads.
To install the switch on a flat surface:
Stick one rubber footpad on each of the four concave spaces on the bottom of the switch.
The rubber footpads cushion the switch against shock and vibrations. They also provide ventilation
space between stacked switches.

Wall-Mount the Switch

The bottom panel of the switch provides four VESA mount holes that allow you to mount the switch to a
wall. The switch ships with wall-mount screws and anchors that you can secure to a wall and attach the
switch to. We recommend that you use all four screws for greater stability and correct positioning. Although
for some positions you could use only two screws, for other positions, using two screws will cause the switch
to tilt.
Note To prevent the switch from tilting, do not wall-mount the switch vertically with the back
panel facing right (that is, with the cables on the right). Whether you use two or four
screws, the switch will tilt in this position.
Installation
25