Returning To The Factory Settings (Factory Reset) - Roland DJ-505 Owner's Manual

System Settings

Returning to the Factory Settings (Factory Reset)

The system settings and TR-S patterns stored in the DJ-505 can be returned
to their factory-set state (factory reset).
1
While holding down the [LOAD] button in the left side (L channel)
of the browser section, and press the [POWER] switch to turn on
the power.
The display indicates " , " and the [START/STOP] button of the TR-S
section blinks.
* If you decide to cancel the operation, turn off the power.
2
Press the blinking [START/STOP] button.
Factory reset begins.
When the display indicates "
NOTE
Never turn off the power until the display indicates "
3
Turn the DJ-505's power off and then on again.
22
, " factory reset is complete.
. "