Mixer Section; Effect Section - Roland DJ-505 Owner's Manual

Mixer Section

This is a two-channel mixer. Here you can adjust the sound, connect sounds, and turn headphone cue on/off.
1
7
8
2
9
10
3
4
11
5
12
6

Effect Section

Here you can adjust the effects using two independent effect sections (FX1, FX2).
2
1 4
1
CH ASSIGN area
[1] button
Turns FX 1 (FX 2) on/off for deck 1.
[SHIFT] + [SLIP] Turns FX 1 (FX 2) on/off for deck 3.
[2] button
Turns FX 1 (FX 2) on/off for deck 2.
[SHIFT] + [SLIP]
Turns FX 1 (FX 2) on/off for deck 4.
[TR/SAMPLER] button
Turns FX 1 (FX 2) on/off for TR-S/SAMPLER.
* In Serato DJ's Sampler panel, set OUTPUT to "A. "
2
Effect parameter knobs
Adjust the character of the specified effect.
[SHIFT] + Effect parameter knob Changes the effect type.
1
[TRIM] knobs
Adjust the volume.
2 [HI], [MID], [LOW] knobs
Boost/cut the volume of the high-frequency,
1
mid-frequency, and low-frequency regions.
3 [FILTER] knobs
Applies a filter to each channel.
If you turn the [FILTER] knob toward the right,
only the high-frequency range is heard.
2
If you turn the knob toward the left, only the
low-frequency range is heard.
4
Channel [CUE] buttons
Turn cue on/off for each channel. The sound of
3 channels whose [CUE] button is lit is output from
the headphones.
4
[SHIFT] + [CUE]
5
Channel faders
5
Adjust the output level of each channel.
6
Cross fader
Switches between the audio output of the left
and right decks.
7
[MASTER LEVEL] knob
Adjusts the master output level.
3
5 1
You can specify the tempo of the
track by the interval at which you
repeatedly press the [CUE] button
(Tap Tempo function).
2 3
4 5
3
[BEATS] knob
Adjusts the time for which the effect is applied.
If you press the knob, the setting is set to "1. "
4
Effect buttons
Turn the effect on/off.
[SHIFT] + Effect button
5 [TAP] button
The interval at which you press this button (tap tempo) specifies the
reference tempo of the effect.
If you long-press the button, the specified tempo is reset.
[SHIFT] + [TAP]
Panel Descriptions
8
[BOOTH LEVEL] knob
Adjusts the output level of the BOOTH OUT jacks.
9 [MIXING] knob
Adjusts the volume balance of the channel
whose Channel [CUE] button is lit and the master
output for phones output.
10
[TR/SAMPLER LEVEL] knob
Adjusts TR-S/SAMPLER output level.
11 TR/SAMPLER [CUE] button
Turns TR-S/SAMPLER output cue on/off.
12
Level indicator
Indicate the output level of each channel and
master.
Changes the effect type.
Switches the effect mode (single FX/multi FX).
7