Adjusting The Performance Pad Sensitivity; Returning To The Factory Settings (Factory Reset) - Roland DJ-808 Owner's Manual

Pad/Button Item
[BD] AUX mode
[SD] Backspin length
TR-S section
[ACC] Reverb type setting for the VT section
SERATO SAMPLER
TR-S pad color scheme
[1]–[5] buttons
[AUTO PITCH] button Adjusts the level during ducking

Adjusting the Performance Pad Sensitivity

1
While holding down the [PANEL] button, press the [POWER]
switch to turn on the power.
The DJ-808 is in system setting mode, and the [START/STOP] button of the
TR-S section is blinking.
2
Press the performance pad whose sensitivity you want to
adjust.
The pad you press is lit red.
3
Use the [VALUE] knob to change the value of the setting.
Value (Bold: default) Explanation
The lower the value, the greater the sensitivity.
0 – 50 – 300
* If the sensitivity is too great, vibrations of the DJ-808 itself might make
the pad operate unintendedly.
Take care not to make the sensitivity excessive.
4
When you've finished making settings, press the blinking
[START/STOP] button.
The display shows " U - ait , " and after a while returns to the normal state.
Value (Bold: default) Explanation
If this is "On, " the input signals to INPUT CH 1–4 and USB 3–4 are output without change to
On , OFF
MASTER OUT when the [INPUT SELECT] switch (front panel) is set to PC.
When applying backspin to the jog dial, this setting lets you make backspin continue longer
than the distance that the jog dial actually rotated.
OFF
OFF , (Short),
Short
nrNL (Normal), Long (Long)
Normal
Long
Specifies the effect that is operated by the [REVERB] knob of the VT section.
Reverb
(Reverb), dd (Delay),
Delay
(Reverb + Delay )
Reverb +
Delay
Specifies the color scheme of the TR-S pads.
1–5 (five types)
To view the color scheme assigned to each of the [1]–[5] buttons, hold down a button.
-6 , -18 , -24 , InF (dB) Adjusts the output level of signals other than the mic when the mic switch is set to "DUCK. "

Returning to the Factory Settings (Factory Reset)

The system settings and TR-S patterns stored in the DJ-808 can be returned
to their factory-set state (factory reset).
1
Hold down the [BACK] button of the browser section, and press
the [POWER] switch to turn on the power.
The display indicates " rst , " and the [START/STOP] button of the TR-S
section blinks.
* If you decide to cancel the operation, turn off the power.
2
Press the blinking [START/STOP] button.
Factory reset begins.
When the display indicates " Oc W , " factory reset is complete.
NOTE
Never turn off the power until the display indicates " Oc W . "
3
After the factory reset is complete, press the [POWER] switch to
turn the power off and then on again.
Backspin operation occurs according to the actual distance of rotation.
Backspin operation is shorter than with the Normal setting.
Backspin operation occurs longer than the actual distance of rotation.
Backspin operation is longer than with the Normal setting.
Reverb is applied.
Delay is applied.
Reverb and delay are applied simultaneously.
System Settings
23