Backing Up Or Restoring Sequencer Data; Returning To The Factory Settings (Factory Reset) - Roland DJ-202 Owner's Manual

System Settings

Backing Up or Restoring Sequencer Data

Backup
Here's how to back up patterns 1–16 and kits (instruments).
1
While holding down the mixer section's SAMPLER [CUE] button,
use a USB cable to connect the DJ-202 to your computer.
The SEQUENCER section's [START/STOP] button blinks, and the
performance pads blink.
2
On your computer, open the "Roland" drive.
3
Open the "BACKUP" folder, and copy all files from dj_prm_kit1.
prm through dj_prm_kit12.prm and dj_prm_ptn1.prm through
dj_prm_ptn16.prm to your computer.
4
When copying is completed, operate your computer to eject
the "Roland" drive.
5
Disconnect the USB cable to power-off the DJ-202.
Restore
Here's how to restore the backed-up sequencer data from your computer to
the DJ-202.
1
While holding down the mixer section's SAMPLER [CUE] button,
use a USB cable to connect the DJ-202 to your computer.
The SEQUENCER section's [START/STOP] button blinks, and the
performance pads blink.
2
On your computer, open the "Roland" drive.
3
Copy the backup files into the "Roland" drive's "RESTORE"
folder.
4
When copying is completed, operate your computer to eject
the "Roland" drive.
5
Press the SEQUENCER section's [START/STOP] button.
The performance pads blink alternately, and then all performance pads
blink.
NOTE
Never turn off the power while the performance pads are blinking
alternately.
6
Disconnect the USB cable to power-off the DJ-202.
MEMO
Sequencer data is compatible between the DJ-202 and the DJ-505.
If the DJ-505's sequencer data is restored to the DJ-202, aspects that
cannot be reproduced by the DJ-202 are automatically optimized.
16

Returning to the Factory Settings (Factory Reset)

The system settings and patterns stored in the DJ-202 can be returned to
their factory-set state (factory reset).
1
While holding down the [LOAD] button in the left side (L
channel) of the browser section, use a USB cable to connect
the DJ-202 to your computer, and continue holding down the
[LOAD] button until the SEQUENCER section's [START/STOP]
button blinks.
* If you decide to cancel the operation, turn off the power.
2
Press the blinking [START/STOP] button.
Factory reset begins.
The MASTER level indicator blinks, and then all buttons and pads are lit.
NOTE
Never turn off the power while the MASTER level indicator is blinking.
3
After the factory reset is complete, disconnect the USB cable to
power-off the DJ-202.