Figure 15
Diagnostic Signal Output
The detector provides an analog signal output for various detector signals for diagnostic
purposes.
Selecting and Plotting Signals
Some of the signals are available on the analog output only when running specific tests
(see following sections). Only one signal can be plotted at any one time.
All values in
NOTE
attenuation 1000 mAU, zero
offset 5%, analog voltage range 1
V full scale.
The following signals are available on the analog signal output and the control display
(select Analog Out VWD as source signal in the Plot-Setup).
For signal descriptions see
NOTE
Table 7
1100 Series Variable Wavelength Detector Reference Manual 73
VWD1 A, Wavelength=254 nm (TEST\TESTCR2S.D)
mAU
250
200
150
100
50
0
0
0.5
Test Chromatogram on Agilent ChemStation (response time 2 seconds)
Table 8
on page 79 refer to the following settings on the user interface :
Diagnostic Signals on Analog Output
Troubleshooting and Test Functions
1
1.5
"Signal Descriptions"
on page 80.
2
2.5
3
3
min