Toshiba TOSVERT VF-nC3 Instruction Manual page 76

4.2.1 Settings in the Easy setting mode
The inverter enters this mode by pressing the MODE key when the Easy setting mode is selected
When you are unsure of something
during operation:
You can return to the Standard monitor
mode by pressing the MODE key
several times.

MODE
y
Standard monitor mode

(1)



 Setting parameters in the Easy setting mode
(1) Selects parameter to be changed. (Turn the setting dial.)
(2) Reads the programmed parameter setting. (Press the center of the setting dial.)
(3) Change the parameter value. (Turn the setting dial.)
(4) Press this key to save the change. (Press the center of the setting dial.)
 To switch to the Standard setting mode, press the EASY key in the Standard monitor mode. "" is displayed,
and the mode is switched.
Easy setting mode (Default registered parameters)
Title







(2)

MODE
(3)

* Parameter title and the setting
value are displayed alternately
D-5
Function
Command mode selection
Frequency setting mode selection
Acceleration time 1
Deceleration time 1
Motor overload protection level 1
Connection meter adjustment
EASY key mode selection
(4)
*
⇔
E6581595
4