Toshiba TOSVERT VF-nC3 Instruction Manual page 197


Input voltage:

Output voltage:

Torque current:

Load factor of inverter:
Note 11: Status monitor of * mark is displayed by  to  and  setting.
The left side character is as following table by each parameter setting number.
Parameter Setting No.
0
 to ,
1

2
3
4
5
6
 to  7
8
9-11
12
13-17
， 18
19-22
23
 to 
24-26
27
28-51
 to ,
52

The voltage displayed is the voltage determined by converting the voltage
measured in the DC section into an AC voltage. The reference value
(100% value) is 200 volts for 240V models, 100 volts for 120V models.
The unit can be switched to V (volts).
The voltage displayed is the output command voltage. 100% reference
value is 200V on both 120V and 240V models.
This unit can be switched to V (volts).
The reference value (100% value) is the rated output current indicated on
the nameplate. The current required to generate torque is calculated from
the load current by vector operations. The value thus calculated is
displayed.
Depending on the PWM carrier frequency (f300) setting and so on, the
actual rated current may become smaller than the rated output current
indicated on the nameplate. With the actual rated current at that time (after
a reduction) as 100%, the proportion of the load current to the rated
current is indicated in percent. The load factor is also used to calculate the
conditions for overload trip ().
LED display
Output frequency
x60.0
Output current
c16.5
Frequency command value
f50.0
Input voltage (DC detection)
y100
Output voltage (command value)
p 90
Input power
k 3.0
Output power
h 2.8
Torque
q 80
Torque current
w 90
- -
Stator frequency
b51.0
- -
**** Arbitrary code from communication
- -
PID feedback value
d40.0
- -
Drive load factor
l 70
- -
During stop : Frequency command value
w50.0
During operation : Output frequency
H-9
Function
Hz / free unit
Hz / free unit
Hz / free unit
Hz / free unit
Hz / free unit
E6581595
Unit
8
% / A
% / V
% / V
kW
kW
%
% / A
-
-
-
-
-
%
-