Husky HU1550CA Manual page 20

PROBLEM OR CONCERN
Leaking water from bottom
of unit
Low pressure
Not building maximum
pressure
Irregular pressure
No water coming out of
Wand
POSSIBLE CAUSE
Manifold Assembly is leaking
water
Pump housing is leaking water
Faucet not fully open or unit is
not receiving a full volume of
water
Screen Filter is clogged
Gun or Hose failure
Kink in the Garden Hose or Hose
is wrapped on a storage wheel
Water leaking from either Hose
or Unit
Garden Hose length is too long Shorten the length of the Garden Hose.
Clogged Nozzle
Air in Pump
No Wand attached to the front
of the Gun
Clogged Nozzle
Sceen Filter is clogged
Kink in the Garden Hose or Hose
is wrapped on a storage wheel
20
SOLUTION
Remove the front cover of the unit. If there is
water leaking anywhere from the Manifold
please contact us at:
customerservice@huskypowerwasher.com
or order a replacement directly online at:
www.huskypowerwasher.com.
Email us at:
customerservice@huskypowerwasher.com
for assistance.
Open the faucet all the way.
Clean the Screen filter as instructed in the
section 6.4.
Replace Gun and/or Hose. Contact us at:
customerservice@huskypowerwasher.com
or order online at:
www.huskypowerwasher.com
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.
Stop water from leaking before using the unit or
contact us if you need assistance.
We recommend a maximum length of 25 to 50
feet for City water supply and 30 feet for Well
water supply.
Clean the Nozzle as instructed in section 6.2.
Let Pressure washer run with Gun trigger depressed
and Wand removed until a steady stream of water
is released.
Attach Click-N-Clean TM Wand to the front of the
Gun. (High Pressure is created with the Wand
and not the Gun).
Clean Nozzle as instructed in section 6.2.
Clean the Sceen filter as instructed in section 6.4.
Unwrap the Garden Hose and lay it out flat to
ensure that there are no kinks in the Hose.
HUSKY 1550