Replacing The Battery - Ingenico Move/3500 Manual

Replacing the battery

It is imperative to use a battery authorized by Ingenico. There is
danger of explosion if battery used is not approved by Ingenico
Remove the terminal from its base
•
Turn it off by pressing
•
Remove the back cover (see section "installing battery")
•
Carefully disconnect battery, following the instructions below
•
a) Unlock the connector by pressing the locking
mechanism as indicated by F1 arrow while
pulling this connector (F2 arrow) Release
traction on it as soon as the connector comes
unclipped
b) Finish extracting connector by tilting it slightly
(F3 arrow) to bring it away from the terminal
housing
Inform the terminal that battery will be replaced (*). To do so, start the
•
terminal without battery by fitting it on its base, or connecting terminal
power supply
Remove terminal from base or disconnect terminal power supply
•
Connect and install the new battery by following the instructions in
•
section 4.5.2 "Installing battery"
Close the back cover and charge the new battery. See section
•
«xxxxxxx0 Charging the Battery»
In order to preserve the environment, dispose used battery at
•
appropriate site in compliance with recycling legislation
(*) The terminal memorizes that there is no battery simply by powering up.
It will then correctly perform a full recharge with the next battery
Page 14
and simultaneously for about one second
Move/3500 User Guide
Copyright© 2017 Ingenico