Charging The Battery - Ingenico Move/3500 Manual

Charging the battery

When does the battery need to be charged?
On initial startup. The battery should be charged for 16 hours under the
environmental conditions stated earlier in this guide.
When used daily on battery power only. The terminal will automatically
recharge its battery each time it is placed on its base.
When used with a terminal power supply: connect the power supply to
Move/3500 power connector.
How can the battery be charged?
Using the base
Place the terminal on its base, charging will automatically begin.
Using the terminal power supply
Connect the terminal power supply unit to the terminal charging port on
the left of the terminal.
The battery symbols are:
Battery charge greater than 80%
Battery charge greater than 60% and less than 80%
Battery charge greater than 40% and less than 60%
Battery charge greater than 20% and less than 40%
Battery charge less than 20%
Terminal powered by external power supply, battery full charge
The environment in which the charge takes place influences battery
lifetime and autonomy (number of transactions)
The optimal conditions are as follows:
Charge away from any external heat source (radiator, sun, enclosed
-
area etc.)
The optimal temperature is between +15° C and +25° C
-
Page 13
Move/3500 User Guide
Copyright© 2017 Ingenico