TRENDnet TEW-753DAP User Manual page 30

TEW-753DAP User's Guide
N Data Rate : Select different 802.11N Modulation and
Coding Scheme (MCS) against particular
wireless noise. Or, select auto letting
TEW-753DAP select MCSs dynamically.
Channel Bandwidth : Select channel bandwidth for
1) Dynamic select 20 MHz and 40MHz
bandwidth or 2) choose 20MHz channels
only�
Preamble Type : Select a short or long preamble. For
optimum performance it is recommended
to also configure the client device to the
same preamble type.
CTS Protection : Clear to Send, CTS, can be always
enabled, auto, or disabled. By enabled
CTS, the Access Point and clients will
wait for a 'channel cleared' signal before
transmitting. It is recommended setting to
auto�
Tx Power : Wireless signal transmission power. Set
transmission power to appropriate value
can make your multiple AP deployment
easier. The default value is 26 dBm. Valid
settings are between 11 and 29.
Apply :
Click this button to apply the change
Cancel : Click this button to abandon the change
Apply : Click this button to apply the change
Cancel :
Click this button to abandon the change
WPS
© Copyright 2013 TRENDnet. All rights reserved.
WPS is the simplest way to connect a wireless client to TEW-753DAP.
You don't have to select the encryption mode and fill in a long
encryption passphrase every time when you try to setup a wireless
connection. You only need to press a button on both wireless client and
TEW-753DAP, and the WPS will do the rest for you.
The TEW-753DAP supports two types of WPS: WPS via Push Button and
WPS via PIN code. If you want to use the Push Button, you have to push
a specific button on the wireless client or in the utility of the wireless
client to start the WPS pairing, and click the Start to Process button in
this page under WPS via Push Button to start WPS pairing.
If you want to use the PIN code, you have to know the PIN code of the
wireless client and switch it to WPS mode, then fill-in the PIN code
of the wireless client through the web configuration interface of the
wireless router.
System Configuration
28