TRENDnet TEW-753DAP User Manual page 22

TEW-753DAP User's Guide
IP Network Setting : Select "Obtain an IP address
automatically (DHCP)" or "Specify
an IP address". If you select specify
an IP address, you have to enter
following information manually. If
SHCP is selected, then the IP address
is received automatically from the
external DHCP server.
© Copyright 2013 TRENDnet. All rights reserved.
IP Address : Specify an IP address
IP Subnet Mask : Specify a subnet mask for the IP
address
Default Gateway : Default route for TEW-753DAP
Primary DNS : Primary DNS server address
Secondary DNS : Secondary DNS server address
Use Link Local Address : Check this to use link local address
IPv6 IP Address : Specify an IPv6 dual-stack address
IPv6 Subnet Prefix Specify a subnet range for the IPv6
Length : address
IPv6 Default Gateway : Default route for IPv6
IPv6 Primary DNS : Primary IPv6 DNS server address
IPv6 Secondary DNS : Secondary IPv6 DNS server address
Spanning Tree
The TEW-753DAP is designed for end point access as well as backbone
connection. To avoid network looping, you can enable 802.1d spanning
tree protocol.
System Configuration
20