Rear Panel - Planet VIP-050 User Manual

SIP Voice Gateway User's Manual
PWR Green
SYSTEM Green
LAN
Ÿ ACT Green
Ÿ 100M Green
Ÿ LNK Green
Ÿ COL Green
Slot A/B Green
Channels
1-4
Ports
VIP is equipped with an Ethernet interface with 10/100 Mbps auto-negotiation capability. The
Ethernet interface port is located on the front panel. In addition to the Ethernet interface port, there
is a 9-pin RS-232 interface port on the front panel. Their functions are described below:
Port
RJ45 LAN
9-pin RS-232 User Console Connecting VIP to a VT-100 terminal or terminal emulator for con-
Reset Button
There is a push button located behind a small hole next to the SYSTEM LED. This button allows
you to reset VIP or force VIP to enter firmware upgrade mode.
Reset
Push a small, stiff object into the hole until the SYSTEM LED stops blinking, then release the but-
ton.
Force firmware download mode:
Powering on the gateway while pressing down the button for 5 seconds forces VIP to enter
download mode
1.5

Rear Panel

The rear panel of VIP-050 has two slots allowing the installation of up to two Telephony-Interface-
Module (TIM) . Each module is equipped with 4 telephony interface ports. Depending on the type of
the telephony interface module, the telephony interface ports may be connected to telephony de-
vices, such as PBX, KTS, and telephone sets of central office. VIP-450 equips with two FXO and
two FXS ports. In addition to the TIM slots (ports), there is an AC power receptacle and a power
switch (power adapter: VIP-450) on the rear panel.
Overview
On Power is supplied to the gateway.
Blinking The system is running. (Heartbeat LED)
On Data is presented on LAN.
On The gateway is connected to LAN at 100Mb/s.
Off The gateway is connected to LAN at 10Mb/s.
On The gateway is connected to LAN.
On Data collision is occurring on the network connection.
Off The line is idle.
On The line is being used.
Blinking The line is ringing.
Label
Connecting VIP to a 10/100 Mbps Ethernet network
figuring VIP
Function
3