Ptt Call To A Single Device - AT&T TL96457 User Manual

Multiple handset use
Push-to-talk (PTT)

PTT call to a single device

Using a handset:
1. There are a few ways to begin a PTT call to a single device. When the handset
is not in use:
If you have one handset, press and hold PUSH TO TALK in idle mode.
f
If you have more than one handset, press PUSH TO TALK in idle mode:
f
Š Use the dialing keys to enter the destination device number (0 for
Š
telephone base, 1-9 for handsets 1-9, TONE and 0 for handset 10,
TONE and 1 for handset 11 or TONE and 2 for handset 12).
-OR-
Š Press
Š
SELECT
The handset displays Connecting to HANDSET X... (HANDSET represents
the handset name, X represents the destination handset number) or
Connecting to BASE 0... (BASE represents the base name) for a few
seconds. When the connection is made, both the initiating handset and the
destination device display Press and hold [PTT] to talk and beep once.
2. Press and hold PUSH TO TALK. A chirp indicates your microphone is on.
Speak towards the handset. Your voice is broadcast to the destination
device. While you are speaking, the handset displays PTT To HANDSET X
(X represents the destination handset number) or PTT To BASE 0.
3. Release PUSH TO TALK after speaking. Both devices beep once again and
the screens show Press and hold [PTT] to talk, then you can press and hold
PUSH TO TALK to continue speaking or the destination handsets can respond
(see Answer a PTT call on page 83).
4. To end the PTT call, press
telephone base or charger. The handset shows Push to talk Ended for a few
seconds.
Note: After PUSH TO TALK is released, the PTT call remains open for a short time. If no one presses
PUSH TO TALK within 10 seconds, the PTT call ends automatically.
or to scroll to the destination device, then press
CID DIR
or PUSH TO TALK.
OFF/ or END, or place the handset in the
CANCEL
79