Replace An Active Device - AT&T TL96457 User Manual

Bluetooth
Bluetooth setup

Replace an active device

If you already have two active devices on the device list and you want to
activate a different device, you must deactivate one of the two active devices.
To replace an active device:
MENU
1. Press
2. Press or
CID
press SELECT.
3. Press or
CID
press SELECT.
4. Press or
CID
activate without a prefix D1: or D2:, then press OPTION.
5. Press or
CID
SELECT. The handset displays Only BT devices in slot 1 or
2 can be ready for connection and then a list of devices
for deactivation.
6. Press or
CID
deactivated, then press NEXT. The screen displays
Cell Phone X is deactivated and you hear a confirmation
tone. Then, the screen displays Connecting Cell Phone Y
to the base... (Cell Phone X and Cell Phone Y represent
the device names of your cell phones).
7. Depending on your cell phone settings, you may need to
press a key on your cell phone to confirm the connection.
When the new device is successfully activated and
connected, the handset displays Device connected. You hear a confirmation
tone.
Note: When connecting a Bluetooth device to the device list, all connected devices will be temporarily
disconnected until the procedure is complete. It may take up to two minutes to reconnect.
on the telephone base in idle mode.
to highlight Bluetooth, then
DIR
to highlight Device list, then
DIR
to highlight the device you want to
DIR
to highlight Connect, then press
DIR
to highlight the device to be
DIR
29
DEVICE LIST
D1:Cel l Phone X
D2:Headset X
Cel l Phone Y
BACK OPTION
Only BT devices
in slot 1 or 2
can be ready
for connection
DEACTIVATE
D1:Cel l Phone X
D2:Headset X
BACK NEXT
Connecting
Cel l Phone Y
to the base...
DEVICE LIST
D1:Cel l Phone Y
D2:Headset X
Cel l Phone X
BACK OPTION