Attaching The Plastic Panel - HP FlexFabric 12900 series Installation Manual

2. Place the power cable bracket to the chassis and align the installation holes on the bracket with
those on the chassis.
3. Fasten the screws to secure the power cable bracket.
Figure 4 Attaching the power cable bracket to the 12910 AC
(1) Screw holes
(3) Screw
(5) Fasten the screws

Attaching the plastic panel

Every 12910 AC switch provides a plastic panel at the lower part of the front panel to protect the air
intake vents and power supply slots. Before installing the plastic panel, install power supplies and
connect power cables first.
To install the plastic panel:
1. Unpack the plastic panel and two clips. As shown in
plastic panel to secure the clips to two sides of the air intake vents.
Skip this step if the clips have been installed to the switch.
1
2
(2) Power cable bracket
(4) Place the power cable bracket to the chassis and align the screw holes
11
4
3
Figure 5, use the screws supplied with the
5