Removing The Twisted Pair And Optical Fiber; Repackaging The Switch Accessories; Repackaging The Plastic Panel - HP FlexFabric 12900 series Installation Manual

Figure 80 Removing the grounding cable
(1) Grounding sign
(3) Loosen the hex nut on the grounding post of the grounding strip

Removing the twisted pair and optical fiber

You must remove twisted pairs and optical fibers from all the interfaces of the switch.
NOTE:
After pulling out an optical fiber from an optical transceiver module, cover the connector of the optical
fiber with a dust cap to keep the connector clean.

Repackaging the switch accessories

Repackaging the plastic panel

Before you remove the power supply, remove the plastic panel from the lower part of the front panel.
To repackage a plastic panel:
1. Prepare the packing bag and box of the plastic panel. Make sure the bag is clean, dry, and not
damaged.
2. Remove the plastic panel from the lower part of the front panel.
For information about how to remove a plastic panel, see
3. Put the removed plastic panel into its bag.
4. Put the packed plastic panel into its box, and tape the flaps of the box with packing tape.
1
2
(2) Remove the grounding cable from the chassis
"Replacement
109
3
procedures."