Spev Setpoint Programming Event Decoder Function Block - Honeywell HC900 Reference Manual
Hybrid control designer
Hide thumbs
Also See for HC900:
- User and installation manual (274 pages) ,
- Installation and user manual (264 pages) ,
- User manual (112 pages)
Table of Contents
Advertisement
Function Blocks
SPEV Setpoint Programming Event Decoder Function Block
SPEV Setpoint Programming Event Decoder Function Block
Description
The SPEV label stands for Setpoint Programming Events .
This block is part of the Setpoint Program and Setpoint Scheduler categories.
Function
Sets up to sixteen digital event outputs that may be ON or OFF on a per segment basis. Inputs include
program number, segment number, and program state (READY, RUN, HOLD, GHOLD, STOP) from
setpoint program block or setpoint scheduler block.
If Program Number (PGM) = 0, Segment Number (SEG) = 0, or Program State (STA) is RESET; then:
•
E1 to E16 = OFF .
Otherwise, E1 to E16 = as specified in program (PGM), segment (SEG).
•
Inputs
= Profile number
PGM
= Segment number (1 to 50).
SEG
= Program/schedule State (Ready, Run, Hold, Ghold, Stop).
STA
340
For SP Programmer - 99
For SP Scheduler - 20
HC900 Hybrid Control Designer Function Block Reference Guide
Revision 11
2/07
Advertisement
Table of Contents
