Table 46 Eight Digital Output Configuration Parameters - Honeywell HC900 Reference Manual

Function Blocks
8DO Function Block
Block properties
Double click on the function block to access the function block properties dialog box.
Configuration parameters
Properties Group
Output 1 through 8 Rack
I/O Module
Channel
Failsafe Failsafe ON
Failsafe OFF
Failsafe
HOLD
150

Table 46 Eight Digital output configuration parameters

Parameter Index #
N/A
N/A
N/A
N/A
1
HC900 Hybrid Control Designer Function Block Reference Guide
Parameter Description
Rack address of selected I/O
Module
Address of select I/O Module
Channel on selected I/O Module
NOTE: If you don't want to use an output pin, leave the
Module # and Channel # at 0.
set the output of the block to OFF
when failure is detected
set the output of the block to ON
when failure is detected
hold the output at the last value just
prior to the failure being detected
If INVERT is selected, Invert IN before writing to output
The slash will be present in the COIL symbol only when the
invert box is selected on the dialog box. (See below.)
Value or Selection
From 1 to 5
From 1 to 12
1 to 8, 9 to 16, 17 to
24, 25 to 32
Select from drop-
down menu
for each Output.
Revision 11
2/07